Siemens Advance Network Gateway User Manual page 42

Setting Network Address & Loop and Unit Numbers,
Instructions
Learning Hint
34 Data Communications Setup
unit:
Unit refers to a numeric number assigned to a de-
vice on the Advance Data Hiway (ADH). Typically
an ANG device can have a unit number from 0- to
31. However, If the ANG is connected to an Ad-
vance Network Interface Unit (NIU), the ANG unit
number must not be set to 0.
iproute:
The iproute variable defines the network path to
the default router. This value may be set to zero if
not used.
1. Log on locally to the ANG_EN.
The Connect Screen will appear with the log in information and the
local prompt. The local prompt indicates that your are communicating
with the ANG_EN connected directly to the PC.
Parameters entered below are not saved until the ANG_EN is reset!
Even though you are given the option to save after each entry you can
make all your entries and then reset to save your entries.
2. To configure the ANG_EN IP address, at the Local
config address ip xxx.xxx.xxx.xxx
Where xxx.xxx.xxx.xxx should be replaced with the 12 digit unique
network address. See Assigning an IP (Internet Protocol) Address
page 37.
Continued
2.0.1
prompt type:
2000590-001