Establishing A Connection - Siemens Advance Network Gateway User Manual

Establishing a Connection

Description
Getting Started
Before You Begin
Password Protection
How to Change
Password
How to Log Out
30 Data Communications Setup
Once your PC is set up, as described in Configuring Your PC, you are
ready to connect to an Advance Network Gateway (ANG_EN).
... read through this Chapter prior to performing any procedures.
1. Ensure that the ANG_EN is not connected to the network by remov-
ing the RJ-45 plug from connector (J6) located on the edge of the
Communications board; reference page 23.
2. Connect a standard 9-pin COM cable from the PC COM port you
designated when you configured your PC (see page 26; step 6. ) to
the Configuration Port J2 located on the Communications Board
(Figure 2-7).
3. Turn on the AC power to the ANG_EN Power Supply board; refer-
ence page on page 17.
All programs on the ANG_EN Communication board are password pro-
tected. This insures the data integrity of all configuration data and limits
unwanted access of the User's network. To access any of the configura-
tion or diagnostic information the user must log in using the password.
A password name can consist of any combination of alphanumeric char-
acters. The alphanumeric name must have a minimum of five and a
maximum of twenty characters. The ANG_EN Communication board is
shipped from the factory with the word "password" entered as the de-
fault password name.
The user can change the password name at any time. To do this login
using the current password then type: "password stand stand". Where
the word stand is the new password entered twice to verify that it was
properly entered.
You may log out or close the Configuration and Diagnostic program at
any time by typing logout. However, the Configuration and Diagnostic
program will automatically log you out after five minutes.
2000590-001