Siemens Advance Network Gateway User Manual page 24

Gateway with ethernet

Hide thumbs Also See for Advance Network Gateway:

Table of Contents

CE Installations,

Installation

Continued

3. A split ferrite must be clamped to Data Hiway cables and fixed im-

mediately to the outside of the ANG_EN; use Siemens Applied

Automation part number 1173000-013 ferrite contained in CE Instal-

lation Kit. This is required to meet the Conducted Immunity require-

ment for CE/EMC Heavy Industrial. All other CE/EMC Heavy Indus-

trial requirements are met without the use of a ferrite clamp.

4. Shielded Ethernet cable must be used for all Ethernet connections,

in and outside the GC, and coupled through the enclosure using a

shielded RJ-45 coupler; use Siemens Applied Automation part num-

ber 1183200-003 contained in CE Installation Kit. A mounting plate

(Siemens part number 2020261-001) is also available to accomplish

this. If needed for Zone 1 installation Siemens Applied Automation

part numbers 2017984-001 and 2017985-001 is available to maintain

purge. If a PG gland is used to make the 360-degree termination of

the Ethernet shield at the enclosure, the Installation Kit and other

parts are not required.

2000590-001

Table of Contents

Troubleshooting