Connecting The Receiver To A Dish Antenna System - Dish Network Satellite Receiver User Manual

Chapter 2
Receiver Description and Installation

Connecting the Receiver to a Dish Antenna System

Page 28
2. Select the
Touch Tone
list.
3. Select either the
No Prefix
list.
Line Prefix
: Usually, you need a telephone number prefix only for business
Note
installations. For most residential installations, all you need to do is set
the telephone system type. The default setting of
correct dialing.
4. If you selected the
No Prefix
5. If you selected the
Prefix Code
(highlighting the top box) where you must enter the digits. To do this, do
the following:
a. Enter the number of digits required to obtain an outside line in the
top box.
b. Move the highlight to the bottom box.
c. Enter the exact sequence you dial the phone to obtain an outside line
in the bottom box.
d. Select the
Save
Note: Before you can begin connecting your receiver to your dish antenna,
you must first complete the preceding sections on connecting your TVs to
the receiver. Once you have a dish antenna system installed and peaked for
maximum signal strength, complete the following instructions to connect the
dish antenna system to the receiver.
1. Connect the cables to the
receiver's back panel as illustrated in the Satellite Connections diagrams
above.
or the
Rotary/Pulse
or the
Prefix Code
option, select
Save
option, the receiver highlights the box
option to save the settings.
and
S I 1
ATELLITE N
option in the
Phone Type
option in the
Outside
will allow
No Prefix
to finish.
ports on the
S I 2
ATELLITE N