Dish Network Satellite Receiver User Manual page 27

9. If your TV is in off-air mode for the channels you picked in step 7, write
"Air" in the blank provided in the margin. If your TV is in cable mode
for the channels you picked in step 8, write "Cable" in the blank
provided in the margin.
10. Set all of your remote TV(s) to the channel mode (Off-Air or Cable)
you wrote in the margin.
11. Tune all of your remote TV(s) to the channel you wrote in the margin.
This is the channel you will use to receive your satellite programming.
12. Turn on the nearby TV (the TV that gets programming from the TV1
outputs).
13. Press the POWER button on Remote Control 1 to turn on the receiver's
green TV1 indicator.
14. You should now be looking at the
TV. Select the
Modulator Setup
press MENU 6-1-5 on Remote Control 1 to get to the
screen.
15. With the
Modulator Setup
Remote Control 1 to do the following:
a. Under , select either
TV2 Out
(for cable channel numbers) based on what you wrote down in
Cable
the margin in step 9.
b. Under , use the up and down arrow buttons to change the
TV2 Out
modulator channel to the one you wrote in the margin in step 8.
c. Select to save the changes.
Done
16. Using Remote Control 2, press the POWER button and make sure the
receiver's blue TV2 indicator turns on.
17. For some TVs, you must run a channel scan so that the TVs will find
and display the selected channel from the receiver. Run channel scan on
all remote TV(s), if available. See your TV user guide for instructions.
C
18. onfirm that you see a picture from the receiver TV2 output, likely the
Point Dish screen, on your remote TV(s).
• If your picture looks good, go to step 26.
• If your TV(s) do not have a picture or if it is not as clear as you
would like it to be, go to the next step.
Connecting the Receiver to the TV(s) in Another Room(s)
Point Dish
, if shown. If the option is not shown,
screen displayed on the nearby TV, use
(for off-air channel numbers) or
Air
screen on your nearby
Modulator Setup
Page 23