System Updates - Dish Network Satellite Receiver User Manual

Chapter 3
Using the System
Telephone Connection Test

System Updates

Page 86
This test checks that the receiver telephone connection is correct. Select the
option to begin the test. The receiver displays a message asking
Connection
you to wait until the test is done.
• If the telephone connection is correct, the receiver displays a
message.
Connection OK
• If the receiver highlights the
the receiver can make a toll-free call to the Customer Service Center.
The receiver displays a message asking you to wait until the call is done.
When the call is done, select the
• If the telephone line is not connected properly, the receiver displays a
failure message. In this case, check the telephone connection and then
repeat the test.
: If you have the receiver connected to a DSL (Digital Subscriber
Note
Line) phone line, it may cause this test to fail. If so, you will need to
install a DSL filter between the receiver and the phone jack on the wall.
You should be able to get a DSL filter from your DSL provider or your
local electronic parts store.
Your receiver includes a feature that allows you to set the time in
which your receiver downloads
feature is enabled, the receiver will shut off every day at the same
Updates
time receive a software update. The default time for this feature is 3:00 a.m.
1. Press the MENU button.
2. Select
System Setup
3. Select .
Installation
4. Select .
Updates
5. Highlight the
Activation
option, select the
Done
option to exit the test menu.
Done
information. When the
Program Guide
.
field.
Phone
option so
Dial Out