Connecting The Receiver To A Dish Antenna System - Dish Network Solo 351 User Manual

Chapter 2
Receiver Description and Installation

Connecting the Receiver to a Dish Antenna System

Page 28
2. Select the
Touch Tone
list.
3. Select either the
No Prefix
list.
Line Prefix
: Usually, you need a telephone number prefix only for business
Note
installations. For most residential installations, all you need to do is set
the telephone system type. The default setting of
correct dialing. If this is the case, select the
above setting, and stop here. If you do need to set a prefix, then instead
of selecting the
Save
4. If you selected the
No Prefix
5. If you selected the
Prefix Code
(highlighting the top box) where you must enter the digits. To do this, do
the following:
a) Enter the number of digits required to obtain an outside line in the
top box.
b) Move the highlight to the bottom box.
c) Enter the exact sequence you dial the phone to obtain an outside line
in the bottom box.
6. Select the option to save the settings.
Save
Note: Before you can begin connecting your receiver to your dish antenna,
you must first complete the preceding sections on connecting your TVs to
the receiver. Then if you are installing a dish antenna system for the first
time, see Chapter 4 - Dish Antenna Installation starting on page 85.
Otherwise, if you already have a dish antenna system installed and peaked
for maximum signal strength, complete the following instructions to connect
the dish antenna system to the receiver.
: You will need two available receiver connection points on your
Note
installed switch or LNBF to complete this installation. If these ports are not
available, you may need to upgrade your system with different or additional
equipment. See DISH Pro Wiring Diagrams in Chapter 4 starting on
page 94.
or the option in the
Rotary/Pulse
or the
Prefix Code
Save
option, go on to step 4.
option, select
Save
option, the receiver highlights the box
Phone Type
option in the
Outside
will allow
No Prefix
option to save the
to finish.