Chapter 2
Receiver Description and Installation
Optional—Connecting VCRs to the System
Connecting a VCR to the Nearby TV
Page 30
10. Once the software upgrade is complete, a message appears stating that
your receiver's memory is being upgraded.
11. Do not disturb the receiver while the receiver's memory is being
upgraded.
: If you are installing other DISH Pro or DISH Pro Plus receivers,
Note
be sure to run
Check Switch
necessary software upgrade.
12. When the memory upgrade is complete, you should be watching TV.
Your dish antenna installation is now complete.
The diagram below provides an example of how to connect VCRs to your
satellite TV system. Your installation may be different.
Tune to remote
TV channel
(for example
channel 60)
Tune to
channel 3 or 4
Remote TV
: Connecting your television directly to the audio/video output of your
Note
receiver will assure a more vivid picture and enhance your viewing
enjoyment.
1. Connect a coaxial cable from the
the nearby VCR's tuner port.
2. Connect a coaxial cable from the output on the VCR to the nearby TV's
tuner port.
3. Plug in and turn on the nearby VCR and TV.
4. Set the VCR output to Channel 3 or 4 as set on page 26.
5. Tune the nearby VCR and TV to Channel 3 or 4 as set on page 26.
on all of them and allow them to take the
Tune to
channel 3 or 4
Tune to
channel 3 or 4
Nearby TV
output on the receiver to
CH 3-4 OUT