Chapter 3
Using the System
Point Dish and Check Switch
Page 88
The Point Dish and Check Switch screens are helpful to the Customer
Service Representative. You may be asked to display these screens when you
call DISH. Even though there are items that can be changed, only change
them when specifically directed by a Customer Serivce Representative.
Warning
has low or no signal results in incorrect receiver settings and
causes you to lose channels. Do not run a Check Switch test
unless directed to by a Customer Service Representative or
other DISH instructions.
1. Press Menu.
2. Select
System Setup
3. Select
.
Installation
4. Select
. This screen shows you information to help maximize
Point Dish
your satellite signal. The bar at the bottom of the screen tells you the
signal strength. Green is a good signal, yellow is a marginal signal, and
red indicates the signal is not acceptable or is from the wrong satellite.
: Running the Check Switch test while the receiver
.