Connecting To Your Dish Antenna - Dish Network Solo 381 User Manual

Chapter 11

Connecting to Your Dish Antenna

C
ONNECTING TO
Use the instructions here if you are connecting a receiver into an existing satellite TV system.
1
Before you can begin connecting your receiver to your dish antenna, you must first complete the
preceding sections on connecting your TVs to the receiver.
2
Connect an RG-6 coaxial cable between the Satellite In port on the receiver's back panel to an
available port on either your switch or your LNBF in your existing system.
Note: If you are installing your receiver into a system with DISH Pro or DISH Pro Plus LNBFs (and/
or switches), you can have as much as 200 feet of cable between the LNBF and the receiver.
However, you must use only RG-6 coaxial cables rated up to at least 2150 MHz. Some cables may
say "Swept tested for 2150 MHz." If you have any doubt about this, ask your DISH Network
retailer, or look on the container the cable came in. Do not use cable company TV cables or cables
from other satellite TV systems not rated up to at least 2150 MHz. These other cables may cause
signal loss. Do not use existing cables such as RG-59. Use waterproof F-connectors outdoors.
3
Peel off the blue sticker and affix it to the cable close to where it connect to the Satellite In
connection on the back of the receiver. The sticker is in the front cover of this guide.
4
On the remote control, press Menu, select System Setup (6), Installation (1), and then Point Dish
(1) to display the Point Dish screen on the TV.
5
Select Check Switch. Select Test.
6
The receiver begins performing the Check Switch tests. When it is finished, the Installation
Summary screen displays.
7
Make sure that the information on the Installation Summary screen identifies your system correctly
and shows all transponders for all satellites in your system.
8
Select OK to go to the Point Dish/Signal screen.
9
Select Cancel to exit the Point Dish menu. At this point, the receiver may walk you through a
procedure to download software. If this prompt displays, follow the instructions and do not disturb
the receiver until the TV is displaying DISH Network video. Otherwise, press View TV. After a few
minutes, you should be watching TV.
72
Y D A
OUR ISH NTENNA