Onnecting To Your Dish Antenna - Dish Network HDTV Satellite Receiver User Manual

C
ONNECTING TO
Connect your TV to the receiver using the previous sections before connecting the
receiver to the dish antenna.
1-2
3
SATELLITE IN SATELLITE IN
Label
Continue with the
cables
Installation Wizard,
programming the
Connect receiver
remote to the receiver.
to dish system
Select Continue
when finished.
1
Connect one RG-6 coaxial cable from the LNBF to a DISH Pro Plus (DPP) Separator or a
DISH Pro Plus Triplexer. Connect the DPP Separator or DPP Triplexer to the S
I port on the receiver's back panel.
N
Note: If you are installing your receiver in a system with DISH Pro or DISH Pro Plus
LNBFs (and/or switches), you can have as much as 200 feet of cable between the LNBF
and the receiver. You must use RG-6 coaxial cables rated up to at least 2150 MHz.
2
Peel off the blue stickers (found at the beginning of this User's Guide) and affix them to the
cable near where they connect to the S
3
Power on the receiver and the TV. Program Remote to Receiver (Step 1 of 5) appears,
which is the first step of the Installation Wizard.
4
Using the remote, press SAT and then press RECORD. A number appears in the box on
the screen. Select Continue. Download Software (Step 2 of 5) of the Installation Wizard
appears.
5
After the software is downloaded and the receiver has been updated, the receiver restarts.
This process can take 10-25 minutes.
Note: Step 2 of 5 eventually fails to proceed if your antenna is not pointed correctly. You
may see a pop-up instructing you to make sure that all cables leading to the receiver are
connected securely and correctly. If this is the case, make sure your antenna is pointed
correctly before selecting Continue on this screen.
6
On the Set Video Resolution screen, select the best resolution supported by your TV.
Select Test. On the confirmation screen, select Save.
7
On the Connect Receiver to Ethernet screen, the system is establishing connection to
broadband Internet. Wait while this process occurs.
8
On the Receiver Setup Complete screen, select Guide to display the Program Guide,
select Live TV to view live programming, or select Preferences to customize the guide
and channel lists (see Customizing the Guide and Channel Lists on page 70).
Y D A
OUR ISH NTENNA
4
5
Wait as the system
downloads software
and updates the
receiver. When
finished the
receiver restarts.
ATELLITE
Connections and Setup
Connecting to Your Dish Antenna
6
7
Select the
Wait while the
best resolution
receiver connects
for your TV.
Select Test to Ethernet
and Save. or Phone.
I connection on the back of the receiver.
N
8
Select Guide to
view the Program
Guide, Live TV to
view Live TV, or
Preferences to
establish your
preferences.
ATELLITE
83