Getting Started - Dish Network Satellite Receiver User Manual

Chapter 1
Introduction
Tip: Remote
Control 1 is used to
control TV1 menus
on the nearby TV.
Remote Control 2
is used to control
TV2 menus on the
remote TV(s).
Page 4

Getting Started

After your system has been installed, order and watch your programming
using the following steps:
Step 1: Ordering Your Programming
1. Using a remote control, press SAT and then press the
blank POWER button. Make sure the TV is also on.
: If you see the DISH logo displayed on your TV
Note
screen, press the SELECT or blank POWER button
on the remote control to view satellite TV
programming.
2. Press the GUIDE button.
You will see that some channels in the
in white. These channels can be viewed immediately. However, many
channels will be in red. You cannot view these channels until you order
programming.
3. Press the SYS INFO button on the remote control to display
the
System Info
4. Call the Customer Service Center at 1-800-333-DISH (3474). A
customer service representative will help you start DISH programming
on your system and will discuss the various programming packages
available.
5. Choose a package and the representative will authorize your
programming.
6. Press SELECT to close the
7. Wait a few minutes and the channels you purchased will turn from red to
white, and can now be viewed.
Program Guide
screen.
System Info
appear
screen.