Dish Network Satellite Receiver User Manual page 62

Chapter 3
Using the System
Page 58
: VCR setup is only available through TV1 menus.
Note
To set up TV1 to control a VCR, use Remote Control 1 at the nearby TV and
do the following:
1. Press the MENU button.
2. Select the
System Setup
3. Select the
Installation
4. Select the
VCR Setup
5. Set the VCR code by doing one of the following:
• Enter the 3-digit VCR code number from the tables starting on page
101, using the NUMBER PAD buttons.
• Highlight each digit of the VCR code, and press the UP or DOWN
ARROW button until you reach the correct number and then press
SELECT.
6. Make sure the VCR is connected to one of the TV1 outputs and is set to
display from the TV1 output to the nearby TV. Consult your VCR user's
guide.
7. Make sure the VCR is turned on. Insert a rewound tape on which you
want to record.
: The receiver only starts and stops the VCR recording, but does not
Note
turn ON the VCR, so you must do this yourself.
8. To test the new code, highlight the
message warning you to make sure the VCR is turned ON.
9. Press the SELECT button to start the test. Your VCR records for a few
seconds, stops, and then rewinds. The receiver displays a message
saying that your VCR test is complete. Follow the instructions on the
message. If your VCR did not do the test, enter another code from the
table. Repeat step 8 and this step.
10. Once you have found the correct VCR code, select the
save the VCR code you entered and return to the
menu.
option.
option.
option.
option. The receiver displays a
Test
option to
Save
Installation and Setup