004: Mullimitr (Multiband Limiter); 005: St.mstlmt (Stereo Mastering Limiter); 006: St.gate (Stereo Gate) - Korg PS60 Parameter Manual

Trigger Monitor
Turning this parameter On will cause the trigger signal to be
output, instead of the effect sound. Use this parameter to
check the trigger signal with EQ applied.
Usually, this should be set to Off.
PEQ Insert
PEQ Cutoff [Hz]
Q
Gain [dB]
These parameters are used to set the EQ amount thatʹs
applied to the trigger signal.
The Limiter determines whether the compression is applied
or not, based on the post‐EQ trigger signal. Setting the
equalizer allows you to set the Limiter to respond to any
frequency band.

004: MulLimitr (Multiband Limiter)

This effect applies the Limiter to the low range, mid range,
and high range of the input signal. You can control
dynamics for each range to adjust the sound pressure of the
low range, mid range, and high range in a different way
from the EQ.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Band-Pass Filters
Low
Envelope - Control
Mid Low Offset
+
Envelope - Control
Mid Offset
High
Envelope - Control
High Offset
Right
Full Quick
Value
parameter parameter
1.0 : 1...50.0 : 1,
←
Ratio
Inf : 1
Threshold
Thresh[dB] –40...0
[dB]
←
Attack 1...100
←
Release 1...100
Low Offset
LowOfs[dB] –40...0
[dB]
Mid Offset
MidOfs[dB] –40...0
[dB]
High Offset
HiOfs[dB] –40...0
[dB]
Gain Adjust –Inf,
Gain [dB]
[dB] –38...+24
Source Off...Tempo
Amount –63...+63
Dry, 1 : 99...
←
Wet/Dry
99 : 1, Wet
Source Off...Tempo
Amount –100...+100
Low Offset [dB]
Mid Offset [dB]
High Offset [dB]
These parameters set the gain of the trigger signal.
Wet / Dry
Limiter
Limiter
Gain Adjust
Limiter
Wet / Dry
Explanation
Sets the signal
compression ratio
p.84
Sets the level above
which the
compressor is applied
p.84
Sets the attack time
p.84
Sets the release time
p.84
Gain of the low-range
trigger signal p.85
Gain of the mid-range
trigger signal p.85
Gain of the high-
range trigger signal
p.85
Sets the output gain
p.84
Selects the
modulation source
for the output gain
Sets the modulation
amount of the output
gain
Sets the balance
between the effect
and the dry input
Selects a modulation
source for Wet/Dry
Sets the modulation
amount for Wet/Dry
IFX (Insert effects) List 004: MulLimitr (Multiband Limiter)
For example, if you do not want to apply compression to the
high range, reduce the "High Offset" value down below the
"Threshold" level. In this way, the high range limiter will
not respond, and compression will not be applied.
005: St.MstLmt (Stereo Mastering
Limiter)
This is a stereo limiter that is optimized for mastering songs.
Stereo In - Stereo Out
Left
+
Envelope - Control
Right
Full Quick
Value
premiered parameter
Threshold
Trsh[dB] –30.0...0.0
[dB]
Out Ceiling
Cell [dB] –30.0...0.0
[dB]
Release [ms] Rel[ms] 0.50...1000.0
Dry, 1 : 99...
←
Wet/Dry
99 : 1, Wet
Source Off...Tempo
Amount –100...+100

006: St.Gate (Stereo Gate)

This effect mutes the input signal when it falls below a
specified level. You can also invert the on/off status of the
gate, or use note‐on/off messages to turn the gate on/off
directly.
Stereo In - Stereo Out
Left
Envelope Source
Side PEQ
+
Envelope Select
D -mod
Right
FX Control BUS 1
FX Control BUS 2
Full Quick
Value
premiered parameter
D-mod,
Envelope Input,
Env Src
Source FX Control 1,
FX Control 2
Fx Control
0...100
Trim
L/R Mix,
Envelope L Only,
R Only
Mid Source Off...Tempo
Wet / Dry
Out Ceiling
Limiter
Limiter
Out Ceiling
Wet / Dry
Explanation
Sets the level above
which the
compressor is applied
p.84
Sets the output gain
Sets the release time
p.84
Sets the balance
between the effect
and the dry input
Selects a modulation
source for Wet/Dry
Sets the modulation
amount for Wet/Dry
Wet / Dry
Gain Adjust
Delay Gate
Envelope - Control
Trigger Monitor
Envelope - Control
Delay Gate
Gain Adjust
Wet / Dry
Explanation
Selects the source to
control the gate: D-
mod control, or use
the input signal or FX
Control Bus 1 or 2 as a
trigger p.84
Sets the trigger input
level from FX Control
Bus 1/2
Selects the control
signal: left and right
linked, left only, or
right only p.84
Selects the source
that will control the
gate when Envelope
Src = D-mod
85