Osc2 Multisample; Osc2 Pitch; Osc Common - Korg PS60 Parameter Manual

Program Edit

OSC2 Multisample

This page controls the basic settings for Oscillator 2. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under "OSC1 Multisample" on page 26.

OSC2 Pitch

This page controls the pitch settings for Oscillator 2. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under "OSC1 Pitch" on page 28.
30

OSC Common

Here is where you can specify the pitch of each oscillator,
the delay time until the oscillator will begin sounding, and
the velocity zone.
Frequency
OSC1, OSC2
Octave
This sets the basic pitch of the Oscillator, in octaves. The
default is 8ʹ. The standard octave of a multisample is 8ʹ.
Transpose
This adjusts the pitch in semitones, over a range of ±1
octave.
Tune
This adjusts the pitch in cents, over a range of ±1 octave. A
cent is 1/100 of a semitone.
Freq Ofs [Hz] (Frequency Offset)
This adjusts the pitch by increments of 0.1 Hz. Frequency
Offset is different from "Tune" in that, when used to detune
the two oscillators, it can create a constant beat frequency
across the range of the keyboard.
Note On Control
OSC1
Delay [ms] [0000ms...5000ms, KeyOff]
This specifies the time from when you press a key until
oscillator 1 actually begins to sound.
This is most useful in Double Programs, for delaying one
oscillator in relation to the other.
KeyOff is a special setting. Instead of delaying the sound by
a particular amount of time, the sound will play as soon as
you release the key. You can use this to create the "click"
heard when a harpsichord note is released, for instance.
In general, when you use the KeyOff setting, it's also best to
set the oscillator's Amp EG "Sustain Level" to 0.
Mode
Normally, you play notes simply by pressing keys on the
keyboard. In special cases, however, you can set this param‐
eter so that you must first be holding down the damper
pedal, and then press a key, in order to play a note. For
instance, this can be useful when modeling the behavior of a
piano soundboard.
Key is the normal mode.
[32' , 16' , 8' , 4']
[–12...+12]
[–1200...+1200]
[–10.0Hz ... +10Hz]
[Key, Key + Damper]