IFX (Insert Effect)
Here, you can adjust settings for the insert effects.
For more information, please see "Effect Guide" on page 79.
The [IFX] and [MFX/EQ] tab pages allow you to edit all of
the effect parameters that cannot be edited from the PS60
itself. Parameter names shown in purple are the effect
parameters that can be edited from the PS60.
Here you can view and edit the settings for the selected
insert effect, its on/off status, and the send level to the mas‐
This specifies the type of insert effect. The direct sound
(Dry) is always input and output in stereo through the
insert effect. The input and output of the effect sound (Wet)
will depend on the type of effect (page 81).
The number of effect types to choose from will depend on
the timbre category.
• Categories A.PIANO, E.PIANO, BRASS, SYNTH: 00–52
• Category ORGAN: 00–54
Programs of the Organ category allow you to use 53:
Organ Vib/Chorus and 54: Rotary Speaker in addition to
effect types 00–52. When using 54: Rotary Speaker, you
can use the ORGAN FAST/SLOW button to switch the
rotary speaker simulator between slow/fast speeds.
• Category STRINGS: The insert effect is not available.
This turns the insert effect on/off.
When off, the input will be output without change. (For 000:
No Effect, the On and Off settings have the same result.)
IFX (Insert Effect) Common KeyTrack (Common Keyboard Track)
These adjust the level at which the post‐IFX signal is sent to
master effects 1 and 2. This is valid if "Bus (Bus Select)" is
set to L/R or Off.
[00...52 (53, 54)]
Separately from this setting, you can use CC#92 to turn
off all insert effects. A value of 0 turns them off, and a
value of 1–127 returns them to their original settings.
This is controlled on the global MIDI channel specified
by ʺMIDI Channel (Global MIDI Channel)ʺ (page 72).
You can use CC#93 to control the Send 1 level and
CC#91 to control the Send 2 level. These are controlled
on the timbreʹs MIDI channel (page 7).