Rack Mounting The Mpx200 - HP MPX200 User Manual

Rack mounting the MPX200

NOTE: Use a crosshead screwdriver to perform the rack mount procedure.
To rack mount the MPX200:
1. Attach the two chassis rails to the MPX200 chassis using three 10-32 x 1/4 in. screws for
each rail. Make sure that the end with the flange is facing the rear of the chassis
(Figure 12 (page
The MPX200 has multiple mounting holes to allow for adjustable setback. Secure the chassis
rails in the desired position if additional room is needed.
Figure 12 Chassis rails
1. Chassis rail
2. Assemble the front and rear rack rails; secure them loosely using four 6-32 x 1/4 in. screws
(Figure 13 (page
Figure 13 Rack rails
1. Rear rack rail
3. Screw, flathead, 6-32 x 1/4 in.
27)).
1
2. Screws, flathead, 10-32 x 1/4 in.
27)).
2. Front rack rail
2
Rack mounting the MPX200
26592b
27