Enabling Single-Direction Chap During Discovery Session And Normal Session - HP MPX200 User Manual

Bidirectional CHAP during discovery session and single-direction CHAP during normal session
Bidirectional CHAP during discovery session and during normal session

Enabling single-direction CHAP during discovery session and normal session

Table 15 (page 99)
session and normal session.
Table 15 CHAP single-direction settings
Source
iSCSI Port
Discovered iSCSI Initiator
iSCSI Presented Target
1
These are examples of secret settings. Configure CHAP using settings that apply to your network environment.
To enable CHAP for the MPX200-discovered iSCSI initiator entry:
If the iSCSI initiator is not listed when you execute the set chap command, do one of the
following:
◦
From HP P6000 Command View, select Hosts, and then select the Add Host tab. Enter
the IQN string.
◦
From the CLI, use the add command to add the iSCSI initiator that will perform the
discovery.
If the iSCSI initiator is listed when you execute the set chap command, then enable the
CHAP secret (for example, CHAPsecret01):
1. Select the index of the iSCSI initiator.
2. Enable CHAP by selecting 0 and then entering the CHAP secret.
To enable CHAP for the Microsoft iSCSI initiator:
1. Click Discovery
To discover iSCSI target portals manually:
a. Click Add under Target Portals.
b. Enter the IP address of the MPX200 iSCSI port.
c. Click Advanced.
d. Select the CHAP Login Information check box.
e. Enter the CHAP secret for the MPX200-discovered iSCSI initiator in the Target Secret box
(for example, CHAPsecret01).
f. Click OK.
The initiator completes target discovery.
To discover iSCSI target portals using iSNS:
a. Click Add under iSNS Servers.
b. Enter the IP address of the iSNS server.
c. Click OK.
2. Click Targets, and then select the appropriate target for login.
3. Click Log On.
4. Click Advanced.
5. Select the CHAP Login Information check box.
lists the settings you use to enable single-direction CHAP during a discovery
1
MPX200 secret settings
Setting (example)
N/A
CHAPsecret01
N/A
Microsoft initiator secret settings
Action
General Tab Secret
Add Target Portal
Log on to Target
1
Setting (example)
N/A
CHAPsecret01
CHAPsecret01
Setting up authentication 99