Enabling Single-Direction Chap During Discovery Session And Bidirectional Chap During Normal Session - HP MPX200 User Manual

# To set a discovery session CHAP username and password for the initiator
# authentication by the target(s), uncomment the following lines:
#discovery.sendtargets.auth.username = username
discovery.sendtargets.auth.username = iqn.1994-05.com.redhat:fc813cac13.sanergy3
3
#discovery.sendtargets.auth.password = password
discovery.sendtargets.auth.password = CHAPSecret01
# To set a discovery session CHAP username and password for target(s)
# authentication by the initiator, uncomment the following lines:
#discovery.sendtargets.auth.username_in = username_in
#discovery.sendtargets.auth.password_in = password_in
Enabling single-direction CHAP during discovery session and bidirectional CHAP
during normal session
Table 16 (page 102)
session and bidirectional CHAP during a normal session.
Table 16 CHAP single-direction settings
MPX200 secret settings
Source
iSCSI Port
Discovered iSCSI
Initiator
iSCSI Presented
Target
NOTE: These are examples of secret settings. Configure CHAP using settings that apply to your network environment.
1. Enable CHAP for the MPX200 discovered iSCSI initiator entry (CHAP can be enabled via CLI
only).
a. If the iSCSI initiator is not listed under the set chap command, do one of the following:
b. If the iSCSI initiator is listed when you execute the set chap command, then enable
CHAP secret (for example: CHAPsecret01).
2. Enable CHAP for the MPX200 iSCSI presented target:
a. Enter the set chap command.
b. Select the Presented Target the initiator will log in to.
c. Enable CHAP and enter a CHAP secret. For example: hpstorageworks
102 MPX200 iSCSI configuration rules and guidelines
lists the settings you use to enable single-direction CHAP during a discovery
Setting (example)
N/A
CHAPsecret01
hpstorageworks
From HP P6000 Command View, select Hosts, and then select the Add Host tab.
Enter the IQN name string.
From the CLI, use the add command to add the iSCSI initiator that will perform the
discovery.
Select the index of the iSCSI initiator.
Enable CHAP by selecting 0, and then entering the CHAP secret.
Microsoft initiator secret settings
Action
General Tab Secret
Add Target Portal
Log on to Target
Setting (example)
hpstorageworks
CHAPsecret0
CHAPsecret01