Setting Up The Iscsi Ports; Fibre Channel Zoning - HP MPX200 User Manual

Figure 33 The set mgmt command.

Setting up the iSCSI ports

The iSCSI ports require an IP address. Enter the set iscsi command to set the IP addresses.
See Figure 34 (page
Figure 34 The set iscsi command

Fibre Channel zoning

Use the following diagram as a guide to implement zones. Use the show vpgroups command
to determine the MPX200 WWNs used in zoning (see
from the MPX200 and the 3PAR array ports.
41).
Figure 35 (page 42)). Zones include WWNs
Setting up the iSCSI ports 41