Issues And Solutions; Hp P6000 Command View Does Not Discover Mpx200; Initiator Cannot Log In To Mpx200 Iscsi Target - HP MPX200 User Manual

Figure 127 iSCSI controller properties

Issues and solutions

HP P6000 Command View does not discover MPX200

Solution 1: Ensure that a DHCP server is available.
Solution 2: Use the CLI to set a static IP address on each MPX200 blade.
Solution 3: Ensure that the HP P6000 Command View station is on the same subnet as the
management ports.
Solution 4: Enter the known IP address of the management port of the iSCSI controller in the HP
P6000 Command View discovery screen.

Initiator cannot log in to MPX200 iSCSI target

Solution 1: Ensure that you are using the correct iSCSI port IP address.
Solution 2: In HP P6000 Command View, for each controller, click the IP ports tab, and verify the
IP Address settings (Figure 128 (page 148)).
Issues and solutions 147