Installing Driver During A Windows Server 2008, Windows Server 2008 R2 Installation; Installing Windows Server 2008, Windows Server 2008 R2, Windows Server 2003 For A New Raid Controller - Dell PowerEdge RAID H700 User Manual

Installing Driver During a Windows Server 2008, Windows Server 2008
R2 Installation
1 Boot the system using the Windows Vista, Windows Server 2008,
Windows 7 Server or Windows Server 2008 R2 media.
2 Follow the on-screen instructions until you reach Where do you want to
install Vista/2008/7 window and then select Load driver.
3 The system prompts you to insert the media. Insert the installation media
and browse to the proper location.
4 Select the appropriate PERC H700 or H800 card from the list, click Next
and continue installation.
NOTE:
for the PERC H700 and H800 cards. For driver updates, see the Drivers and
Downloads section at support.dell.com.
Installing Windows Server 2008, Windows Server 2008 R2, Windows
Server 2003 for a New RAID Controller
Perform the following steps to configure the driver for the RAID controller on
a system that already has Windows installed:
1 Turn off the system.
2 Install the new RAID controller in the system.
For detailed instructions on installing and cabling the RAID controller in
the system, see "Installing and Configuring Hardware" on page 41.
3 Turn on the system.
4 The Found New Hardware Wizard screen displays the detected hardware
device.
NOTE:
system automatically detects the controller and installs the drivers. Check the
version of the driver and update if required.
5 Click Next.
6 On the Locate device driver screen, select Search for a suitable driver for
my device and click Next.
7 Browse and select the drivers from the Locate Driver Files screen.
8 Click Next.
72
Driver Installation
The Windows Server 2008 R2 operating system includes native drivers
Windows Server 2008 R2 has native drivers for the PERC adapters. The