Cisco DPC2434 User Manual page 93

Field Name
Subnet
Mask
Identity type
Identity
4011350 Rev D
Description
Allows you to enter Subnet information based on the selected
Address group type.

For IP subnet, enter the subnet

For Single IP address, enter only the specific IP address

For IP address range, enter the starting and ending IP
addresses
Allows you to enter Mask information based on the selected
Address group type.

For IP subnet, enter the subnet mask

For Single IP address, enter only the specific IP address in the
Subnet field. Leave this field blank.

For IP address range, enter the starting IP and ending IP
addresses
Allows you to select the local Identity type from one of the
following options:

WAN IP address of the router(default)

User-specified IP address

Fully qualified domain name (FQDN)

Email address
This is the identity that the far endpoint will use for identification
of the VPN termination point. The remote VPN endpoint on the
other end of the tunnel should match these settings for its remote
endpoint settings
Allows you to enter the identity string after you have selected the
identity type using one of the following formats:

For IP address mode use the format xxx.xxx.xxx.xxx

For FQDN use the format "yourdomain.com"

For email address use the format
"yourname@yourdomain.com"
The remote VPN endpoint on the other end of the tunnel should
match these settings for its remote endpoint settings
How Do I Configure the Wireless Home Gateway?
93