Cisco DPC2434 User Manual page 43

To install wireless network devices
WARNING:
Hazardous electrical voltages can be present on any connected wiring.
Ethernet wiring and connections must be properly insulated to prevent
electrical shock. Disconnect power from the wireless home gateway before
attempting to connect to any device.
To avoid personal injury, follow these steps in the exact order shown.
CAUTION:
To prevent possible damage to the equipment, disconnect any other service
before connecting your wireless home gateway to other devices.
Read the warnings and caution on this page. Then, follow the subsequent
installation procedures to ensure proper wireless home gateway operation when
using wireless network devices.
Installing Wireless Network Devices
Follow these steps to install the wireless home gateway for accessing wireless
network devices.
1 Select locations for wireless network devices. For more information, see How Do
I Select and Place Wireless Network Devices? (on page 41).
2 Connect and install the wireless network device(s).
3 Connect the active RF coaxial cable to the CABLE connector on the back of the
wireless home gateway. Use an optional cable signal splitter to add a TV, a
DHCT or set-top converter, or a VCR.
4 After all connections are complete, insert the AC power cord into the POWER
connector on the back of the wireless home gateway, and then plug the power
cord into an AC power source. The wireless home gateway begins an automatic
search to locate and sign on to the network. In some unusual circumstances, this
process may take up to 5 minutes. The wireless home gateway is ready for use
when the ONLINE LED status indicator on the front panel stops blinking and
illuminates continuously.
Note: Some 2.4 GHz cordless telephones can interfere with wireless signals.
Unplug and disconnect any cordless phones until your wireless network is
operating properly.
5 Verify that all wireless network devices are working properly.
4011350 Rev D
How Do I Install Wireless Network Devices?
43