Cisco DPC2434 User Manual page 90

How Do I Configure the Wireless Home Gateway?
Setup Advanced Settings - VPN Termination - Status Page Description
This section describes the section headings and field descriptions of the Setup
Advanced Settings - VPN Termination - Status page. This page allows you to create,
configure, and control IPsec VPN tunnels.
Note: You can set up and mange up to 50 different VPN tunnels.
Field Name
IPsec Endpoint
Name
Status
Control
Configure
Add New Tunnel
Event Log
90
Description
Enables/disables the IP sec endpoint mode
Displays the user-defined tunnel name entered from the VPN Setup
page
Displays the current connection state (Connected/NOT Connected)
Displays one of the following three keys based on the current tunnel
enable and connection state:

Enable

Connect

Endpoint disabled
Displays Edit or Delete keys used for settings management
Allows you to create a new tunnel configuration. When you click Add
New Tunnel, the VPN Setup page opens
Allows you to access the Event Log page. The Event Log page shows a
history of VPN connections and activity in chronological order and also
displays the IP address of both endpoints on the tunnel (local and
remote)
Note: On the Event Log page, pressing the Refresh key updates the
Event Log table to show any changes since the page was loaded.
Pressing the Clear key clears the log table of its current contents and
only the most recent data appears
4011350 Rev D