Cisco DPC2434 User Manual page 18

Back Panel Description
External Power Supply Model
DPC2434 or EPC2434 (with external power supply)
Important: Do not connect any single PC to both the Ethernet and USB ports at the
same time. Your wireless home gateway will not function properly.
1 CABLE—F-connector connects to an active cable signal from your service
provider
2 15VDC—Connects the wireless home gateway to the AC power adapter that is
provided with your wireless home gateway
3 RESET
Soft Reset—Pressing the Reset switch momentarily (less than 1 second)

initiates a "soft" reset of the wireless home gateway. A soft reset causes the
gateway to restart and to re-register on the network. A soft reset will not
erase your personal settings configured in the gateway.
 Factory Reset—Activating this switch resets the EMTA. Pressing the reset
switch and holding it in for more than ten seconds resets the device to
factory default values and restarts the EMTA. A factory reset will reset all
settings to the original factory settings and will erase all your personal
settings configured in the gateway.
4 ETHERNET—Four RJ-45 Ethernet ports connect to the Ethernet port on your PC
or your home network
18
CAUTION:
Avoid damage to your equipment. Only use the power supply
that is provided with your wireless home gateway.
CAUTION:
The Reset button is for maintenance purposes only. Do not use
unless instructed to do so by your service provider. Doing so may
cause you to lose any cable modem settings you have selected.
4011350 Rev D