Table of Contents
Advertisement
Installing batteries in the remote control
The remote control uses two AAA batteries.
Warning: Keep batteries away from children. If a battery is swallowed, seek medical help
immediately.
1. Release the tab and lift off the cover.
2. Insert two new AAA batteries as shown.
3. Insert the tab into the cover and press it down until it
clicks into place.
Aim the remote control at the screen, or at the front or back of
the projector. Make sure you are within 20 feet (6 m) of the
projector.
If you suspect the batteries are weak, press the
buttons do not glow, replace the batteries.
Turning the projector on and off
Turning on the projector
1. Use the A/V mute slide to open the lens cover.
2. Turn on any connected equipment you plan to use.
3. Press the Ppower button on the remote control or on
the projector.
Note: To prevent children from turning on the projector, you
can use the Child Lock feature. See page 46 for details.
If you'll be using the projector at an altitude above 4921 feet (1500 meters), turn on High Altitude
Mode so the fan can properly cool the projector at high altitude air pressure. See page 48 for
details.
The projector takes about 30 seconds to warm up and display an image. If you don't see a picture,
you may need to change the image source as described on page 36.
Warning: Never look into the projector lens when the lamp is turned on; the bright light can
damage your eyes. Never let children and pets look into the lens when it is on.
illumination button. If the playback control
Setting up the projector
17
Advertisement
Table of Contents
