Table of Contents
Advertisement
Projecting from an iPod, iPhone, or
iPad
The projector features a dock that allows you to connect an iPod, iPhone, or iPad and charge
it while you play back media stored on the device.
Note: The term "iPod" is used in this manual to describe an iPod, iPhone or iPad unless
otherwise noted.
Tip: When your iPod is connected to the projector, it charges whenever the projector is on,
including when the projector is in standby mode.
Connecting an iPod or iPhone
1. Remove the protective case from your device, if necessary.
2. Eject the dock by pressing on it until it clicks, then release it. The dock slides out.
3. Support the dock with one hand and connect the device by aligning it with the dock
connector and gently pushing it straight down as shown.
Caution: To prevent damage, do not apply too much pressure when connecting your device.
Projecting from an iPod, iPhone, or iPad
19
Advertisement
Table of Contents
