Epson PowerLite Presenter i/i+ User Manual page 65

Lights indicating a problem
Light state
All lights are off
The temperature
light flashes orange
and the
light and button are
flashing
The temperature
light is red
The lamp light
flashes orange and
the P
and button are
flashing
The lamp light
flashes red
Both warning lights
are flashing red
Cause and solution
The projector is not receiving power. Make sure the power
cord is connected securely at both ends.
High-speed cooling is in progress. If the temperature rises
further, projection will stop automatically. Make sure there
P power is plenty of space around the projector for ventilation. Clean
or replace the air filter if necessary (see page 58).
If you are using the projector at an altitude above 4921 feet
(1500 meters), turn on High Altitude Mode so the fan can
cool the projector properly (see page 48).
The projector is too hot, which turns off the lamp
automatically. Let the projector cool for five minutes, then
turn it back on. Make sure there is plenty of space around
the projector for ventilation. Also, clean or replace the filter
if necessary (see page 58).
If you are using the projector at an altitude above 4921 feet
(1500 meters), turn on High Altitude Mode so the fan can
cool the projector properly (see page 48).
The lamp needs to be replaced. If you just replaced the
lamp, make sure the lamp and its cover are securely
power light installed (see page 59).
The lamp may be incorrectly installed, or the lamp may be
broken. Turn off the power, wait for the lamp to cool off,
and check the lamp (see page 59). If the lamp is broken, or
the lamp light continues to flash after you turn the power
back on, turn off the projector and contact Epson for
assistance.
If you are using the projector at an altitude above 4921 feet
(1500 meters), turn on High Altitude Mode so the fan can
cool the projector properly (see page 48).
Clean or replace the filter if necessary (see page 58).
There is an internal problem. Turn off the projector, and
unplug it from the electrical outlet. Then contact Epson for
assistance (see page 70).
65
Problem Solving