Cannondale ATV Owner's Manual page 92

12. Loosen and remove the inlet fitting. Then, remove
the inlet filter (screen) from the hole.
1. Inlet filter (screen)
13. Clean the screen using compressed air.
14. Inspect the inlet fitting, 0-ring, and inlet screen for tears,
cracks, and other damage. Replace any damaged part
with a new one.
15. Reinstall the filter into the crankcase. Inspect the fitting
O-ring and replace it with a new one if necessary.
16. Apply light coat of clean engine oil to the fitting O-ring.
90
1
17. Install the fitting. Tighten it to the specified torque.
(2)
(1)
1. Screen
2. O-ring
3. Inlet fitting
4. Clamp
5. Spar return hose
6. Heat shield
18. Reinstall the engine oil inlet hose and clamp onto the
fitting.
19. Re-position the heat shield up to the clamp.
20. Add 1US quart of the specified engine oil in the dipstick
hole at the right frame spar using a clean funnel.
21. Reinstall dipstick and run engine for 1 minute at idle
speed to circulate the new oil.
22. Remove the dipstick and recheck the level. The oil level
should be between the dipstick markings. Add as
required.
(4)
(6)
(5)
(3)