Cannondale ATV Owner's Manual page 85

Idle speed adjustment
The idle speed adjustment screw is located on the
throttle body. It is accessible from the left side of the
vehicle. A special diagnostic tool is necessary to
communicate with the vehicle ECU and accurately read
(display) the engine rpm. For this reason, idle adjust should
be left to a Cannondale service technician.
1. To adjust the idle, allow the engine to reach operating
temperature 158°F (70°C).
2. Set the idle speed by turning the adjuster (1) in
direction (a) to increase idle speed, or direction (b) to
decrease idle speed.
b
1. Adjuster
a. Increase (clockwise)
b. Decrease (counterclockwise)
1
a
Throttle lever adjustment
See "2002 Model Specifications" starting on page 161.
Loosen locknut and then turn the adjuster until the
specified freeplay is reached. Tighten the locknut.
1
1. Rubber boot
2. Locknut
3. Adjuster
NOTE :
If the proper adjustment cannot be obtained or the
throttle lever does not operate properly, the cable end
at the throttle body can be adjusted, however, access to
it is difficult and should be left to a qualified service
technician. See your Cannondale motorsports dealer
for servicing.
3
2
83