Cannondale ATV Owner's Manual page 114

Bleeding the hydraulic clutch
1. To bleed, remove the master cylinder cover and slave
cylinder bleed bolt cap.
2. Attach a clean syringe filled with SAE 10 (mineral
hydraulic oil) to the bleeder bolt at the slave cylinder.
1. Syringe
2. Tube
3. Bleeder bolt
112
3. Loosen the bolts and slowly compress the syringe until
only oil, (no air bubbles) is discharged at the bore of the
master cylinder. Make sure the oil does not overflow out
of the master cylinder.
1. Bore
CAUTION
After bleeding, make sure the fluid level in the
master cylinder is correct.