Engine Stop/Start Buttons (Mc500) - Cannondale ATV Owner's Manual

ENGINE STOP/START BUTTONS (MC500)

1. Engine stop button
2. Engine start button
Engine stop button
The engine stop button is located on the left handlebar
close to the inside edge of the handle grip and is red in
color. Press the stop button to shut off the running engine.
It is also an emergency control. Test the stop button before
moving off to ride to confirm that it is operating properly. If
the switch does not "kill" the engine, don't ride the ATV.
Turn the ignition switch to the "OFF" position and contact a
Cannondale motorsports dealer to have it replaced.
NOTE :
The stop button is a "normally closed" circuit switch. If
the switch is damaged or the wires are frayed or torn,
(i.e. circuit open) the engine will not start.
Engine start button
The engine start button is green in color and is mounted
closer to the center of the handlebars. Pressing it activates
the engine management system circuits and the starter
motor. Make sure it operates properly before each ride.
23