Cannondale ATV Owner's Manual page 110

photo). Use only moderate force when tightening the
preload nut. Using greater force on the preload nut
(e.g., cheater bars, pipe wrenches, etc.) will not extend
the maintenance interval for the brake disc carrier it will
damage the nut and axle assembly.
1. Allen bolts (2 of 3 visible in photo)
6. Tighten the allen bolts uniformly. They should be
tightened snug. Do not over-tighten them.
7. Reinstall the protective boot and recheck the rear brake
disc carrier for play. If play is still present, do not ride the
vehicle; contact an authorized Cannondale motorsports
dealer for servicing
108
Rear pedal height adjustment
The rear brake pedal can be adjusted for comfort as well
as proper operation.
1. Loosen the locknut on the master cylinder pushrod.
Turn the hex on top of the pushrod until the brake pedal
is at the correct height. Turning the hex nut in direction
(b) will lower the brake pedal and turning the hex in
direction (a) will raise the brake pedal.
2
a
1. Locknut
2. Hex nut
a. raise
b. lower
2. Tighten the locknut to the specified torque.
1
b