Advertisement
Quick Links
Should you require assistance or further information please contact your Cannon distributor.
Date installed: ...............................................................................................
Installed by: ...................................................................................................
Compliance Certificate No .............................................................................
For service to this appliance or spare
parts contact the CANNON distributor:
Phone: 1300 727 421
Fax:
1300 727 425
email: service@sampfordixl.com.au
DON'T RISK YOUR
APPLIANCE WARRANTY
ONLY A LICENSED PERSON
WILL GIVE YOU A
COMPLIANCE CERTIFICATE,
SHOWING THAT THE WORK
COMPLIES WITH ALL THE
RELEVANT STANDARDS.
AND ONLY A LICENSED
PERSON WILL HAVE
INSURANCE PROTECTING
THEIR WORKMANSHIP FOR 6
YEARS.
SO MAKE SURE YOU USE A
LICENSED PERSON TO
INSTALL THIS APPLIANCE
AND ASK FOR YOUR
COMPLIANCE CERTIFICATE
TO ENSURE THE
MANUFACTURERS
APPLIANCE WARRANTY WILL
BE HONOURED.
Cannon
Freestanding kit
Part No: F3771
Revision A - 2010
Cannon
Freestanding kit
to suit
Fitzroy Inbuilt heaters
INSTALLATION INSTRUCTIONS
Gmk10025
AS4553:2008
PLEASE READ THIS MANUAL
BEFORE INSTALLING AND
USING THIS PRODUCT.
Read these instructions in conjunction
with heater installation instructions
Please leave instructions with the owner
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Cannon Fitzroy
Summary of Contents for Cannon Fitzroy
- Page 1 COMPLIANCE CERTIFICATE TO ENSURE THE MANUFACTURERS APPLIANCE WARRANTY WILL BE HONOURED. Should you require assistance or further information please contact your Cannon distributor. Date installed: ....................Installed by: ....................Compliance Certificate No ................PLEASE READ THIS MANUAL BEFORE INSTALLING AND For service to this appliance or spare USING THIS PRODUCT.
- Page 2 Contents 125 mm FLUE COWL APPROVED TO AG 604 Mounting heater in freestanding body Pg 2-4 500 mm IF THE COUPLING IS ABOVE MINIMUM ROOF LEVEL SEAL JOINT WITH SILICONE TO PREVENT WATER INGRESSION Minimum clearances Pg 4 FLASHING TO PROVIDE A WATERTIGHT SEAL MAINTAIN 25 mm MINIMUM Gas and Electrical connections...
- Page 3 Flue installation Mounting heater in freestanding body This Flue and Cowl system shall be installed only by an authorised person and in accordance with the manufacturers installations (below), local gas fitting regulations, municipal building codes, AS 5601 Gas Installations and any other statutory regulations.
- Page 4 11. Lift and slide heater into the freestanding body (Figure 6). 12. Secure the heater by screwing the four retaining screws through the front flange and into the freestanding body. Re-attach the flue spigot using the same three screws Figure 3 that were previously removed.
Need help?
Do you have a question about the Fitzroy and is the answer not in the manual?
Questions and answers