Clean The Opc Belt (Right) - Oce VarioPrint 6000 series User Manual

Clean the OPC belt (right)

Clean the OPC belt (right)
Introduction
This procedure is only intended for key operators who received the special
maintenance training.
When to do
When each 7th print contains a pollution at exact the same location.
Before you begin
Make sure that you have the Cleaner P and the offset pads at hand.
Required tools
D-wrench (supplied with the machine)
Socket wrench 10 (supplied with the machine)
Heat-resistant gloves (supplied with the machine)
Adhesive tape (supplied with the machine)
Open the doors
Use socket wrench 10 to loosen the bolt of the front doors (1).
1.
Open the front doors (2).
2.
[69]
[69] Open the front doors
Unlock the OPC unit
Use the D-wrench to push and turn K1 clockwise.
1.
Use the D-wrench to turn K2 clockwise.
2.
Use the D-wrench to push and turn K3 clockwise.
3.
Use the D-wrench to push and turn K4 clockwise.
4.
54 Chapter 3 Maintenance tasks - Level 2
2
1