Table of Contents
Advertisement
Clean the OPC belt
Attention: Do not touch the OPC belt with your fingers.
Rotate the metal OPC pulley until the spots are visible.
1.
[64]
[64] Rotate the OPC pulley
Apply a small amount of Cleaner P on an offset pad.
2.
Clean the spot with this offset pad.
3.
Carefully remove all Cleaner P from the OPC belt. Use new offset pads for
4.
this.
Lock the OPC unit
Rotate the metal OPC pulley until the end of the back side of the OPC belt
1.
runs near (+/- 0.1 inch) the arrows of the yellow registration board.
[65]
[65] Reposition the OPC belt
Clean the OPC belt (left)
51
Advertisement
Table of Contents
