Figure 2-6 Wiring Connections Shown On Board; Figure 2-7 Audio And Alarm Pins - Honeywell HD4 EQUIP Series User Manual

Document 800-05620 Rev C
04/10
Figure 2-6 Wiring Connections Shown on Board
Caution For secure installations, surface-mounted cables should be protected
by plastic or metal cable covers.
Caution Installation must be performed by a qualified electrician. The power
wire size for the distance and the number of cameras must be
determined to maintain 24 VAC at each camera.
Caution Connect power either from a 24 VAC source or a CAT5 Ethernet
connector (PoE); never both at the same time.
Connect Audio and Alarms
Locate the eight-pin green connector that was shipped with your camera and make all the
necessary connections.
Figure 2-7 Audio and Alarm PINs
1
2 3
HD4 EQUIP Series IP Dome Cameras User Guide
RJ45 Ethernet Connector
(see
CAT5 Ethernet
This is also the connection for
Power over Ethernet (PoE 802.3 af)
Audio: Input / Output
Alarm: Input / Output
(see
4 5 6
Connecting to a Network via
Connector, page 27)
Power 24 VAC
Local video out
Connecting Alarms, page 26)
8
7
25