Connections - Honeywell HWC-S363-RV Instruction Manual

Connections

How to Connect RS485
The dome camera has a built-in RS-485 receiver so that it can be controlled remotely by
an external control device such as a joystick controller or a DVR.
RS-485: Connect the TX and TX- of the RS485 control devices (KBD, DVR...) to RX+,
RX- of the dome camera.
RS-485 does not allow for a star connection layout. A splitter is required if a star
connection layout is desired. RS-485 guarantees 1.2 Km of data line routing. A repeater is
recommended to extend over 1.2 Km.
Connecting Video output
Figure 2 – Basic installation diagram
Connecting Alarms
 AL1 to 4 (Alarm In)
Magnetic, PIR or other external sensor devices can be used to signal the dome camera
reacting to an event.
 GND (Ground)
NOTE: All the connectors marked GND are common.
Connect the ground of the Alarm input and/or alarm output to the GND connector.
 NO (Normally Opened dry contact relay output)
The dome camera can activate external devices such as buzzers or lights using dry
contact relays. Connect the device to the NO (Alarm Out) and COM (Common) connectors.
Connecting the Power
Connect DC 12V 3A power to the dome camera.
PTZ SPEED DOME CAMERAS
14