Table of Contents
Advertisement
Installing the Honeywell IP Utility and the Web-Client Software
42
Note
It is important to click Apply to save any configuration change.
1.
Log onto the Web-Client. There are two ways to launch the Web-Client and log on—
via the Honeywell IP Utility program or directly from Internet Explorer.
Honeywell IP Utility
a.
Log onto the Honeywell IP Utility program.
b.
From the Discovery pane, click to select the device and launch its browser.
c.
To enable or disable the HTTP server, select or clear the Enable HTTP Server
check box. By default, the HTTP server is enabled.
d.
From the System tab, click Launch Browser.
The Web-Client application for the selected device opens in Internet Explorer.
Internet Explorer
From Internet Explorer (v6.0+), enter the URL (IP address of the device) in the
Address bar to open the logon window.
2.
Select a User Name and enter a Password.
a.
From the User Name drop-down list, select Administrator or Guest.
b.
In the Password field, enter the case-sensitive password.
•
The default Administrator password is 1234.
•
The default Guest password is guest.
c.
Click
.
3.
A signed version of ActiveX® control is installed when you use the Web-Client to
discover connected devices for the first time. If you have a previous version of the IP
ActiveX is installed, then you are prompted to upgrade the Honeywell secure ActiveX
control.
Figure 3-5
ActiveX Prompt
Click Yes.
4.
Follow the InstallShield Wizard prompts to install the secure Honeywell IP ActiveX on
your PC.
Advertisement
Table of Contents
