Table of Contents
Advertisement
Installation and Setup
Step 9. Adjusting the Camera
28
Connecting to a Video Monitor
The local video out connection (see
and should be used during installation to position, aim, and focus the camera, as needed.
Connect from the local video out connector on your camera to the video input connector
on your spot monitor.
Adjust the FOV (Field of View)
To adjust the your camera:
1.
Verify that power is supplied to the camera.
Note
Please allow the camera to initialize before proceeding. Video output is not
instantaneous with the application of power.
2.
Reinstall the gimbal by inserting the black tabs into the black clips on the enclosure
base.
3.
Connect the supplied video cable to the local video out connector to view the video
signal on a standard monitor (see
connector).
4.
Loosen the setscrew that locks the gimbal assembly in place (see
adjust the horizontal rotation.
5.
Adjust the camera gimbal to the desired view.
6.
Re-tighten the locking screw to lock the gimbal assembly in place.
Note
Figure 2-10
illustrates the ways in which you can adjust your camera.
Caution
Adjust the camera field of view only by moving the gimbal. Do not
move the camera lens to adjust the camera field of view as this might
result in irreparable damage.
Figure 2-6
or
Figure
2-10) is available as a test output
Figure 2-10
for the location of the local video out
Figure
2-10) to
Advertisement
Table of Contents
