Connecting The Sensor/Relay Device - Avermedia XR8032 User Manual

1.6

Connecting the Sensor/Relay device

The I/O card enables you to connect (8) sensor inputs and (8) relay outputs. Just connect
the external sensor and relay pin directly to the I/O card pinhole. Check the table below and
locate which pinhole is assigned to sensor input and relay output. The two set of I/O card
pinhole are the same.
1 2 3 4 5 6 7 8 9 10 11 1213 1415 16 17 1819 20
SENSOR IN
The signal from the sensor (i.e., infrared sensors, smoke detectors, proximity sensors, door
sensors, etc.) is being transmitted to the I/O card and this triggers the system to respond
and send signal to relay device (i.e., alarm, telephone etc).
Pin #
1
2
3
4
5
6
7
8
9
10
Definition
Sensor 1/5 input signal
Sensor 1/5 Ground
Sensor 2/6 input signal
Sensor 2/6 Ground
Sensor 3/7 input signal
Sensor 3/7 Ground
Sensor 4/8 input signal
Sensor 4/8 Ground
Relay Common 1/5
Relay Normal Open 1/5
RELAY OUT
Pin # Definition
Relay Normal Close 1/5
11
Relay Common 2/6
12
Relay Normal Open 2/6
13
Relay Normal Close 2/6
14
Relay Common 3/7
15
Relay Normal Open 3/7
16
Relay Normal Close 3/7
17
Relay Common 4/8
18
Relay Normal Open 4/8
19
Relay Normal Close 4/8
20
4