Connecting The Sensor And Relay Device - Avermedia AVerDiGi MXR6004 User Manual

1.4.3 Connecting the Sensor and Relay device

The Sensor, Alarm, and audio port enable you to connect 4 sensor inputs, and 1 relay outputs.
Just connect the external sensor, relay, and audio in/out device pin directly to the pinhole.
Check the table below and locate which pinhole is assigned to sensor input, relay output, and
audio in/out.
The signal from the sensor (i.e., infrared sensors, smoke detectors, proximity sensors, door
sensors, etc.) is being transmitted to the unit and this triggers the system to respond and send
signal to relay device (i.e., alarm, telephone etc).
Sensor and Alarm pinhole:
Number Pin
1 1
2 G
3 2
4 G
5 3
6 G
7 4
8 G
9 Alarm OUT
10 Alarm OUT
Definition
Sensor 1 signal
Sensor 1 Ground signal
Sensor 2 signal
Sensor 2 Ground signal
Sensor 3 signal
Sensor 3 Ground signal
Sensor 4 signal
Sensor 4 Ground signal
Relay signal
Relay signal
6