CyberData 930274L Operation Manual page 65

4. Click the Update Firmware button to open the Upgrade Firmware page. See
5. Click Browse, and then navigate to the location of the V2 Speaker firmware file.
6. Click Submit.
Note
Note
Operations Guide
Figure 2-28. Firmware Upgrade Page
This starts the upload process. Once the V2 Speaker has uploaded the file, the Uploading
Firmware countdown page appears, indicating that the firmware is being written to flash.
The V2 Speaker will automatically reboot when the upload is complete. When the
countdown finishes, the Upgrade Firmware page will refresh. The uploaded firmware
filename should be displayed in the system configuration (indicating successful upload and
reboot).
If you are upgrading an older version of the Speaker firmware to version 3.3.0 or later,
several features will be in an unknown or random state. Therefore, in the case of a firmware
upgrade to version 3.3.0 or later, CyberData recommends that you go to the Device Config
page and make sure the following values are set properly.
• Auto Answer
930274L
Installing the VoIP V2 Speaker
Configure the Speaker Parameters
Figure 2-28.
CyberData Corporation
58