Connection; An Example Of Standard Connection; Cautions On Connection - Toshiba IK-CU51 Instruction Manual

4. CONNECTION

4.1 An Example of Standard Connection

Camera
Lens
head (Option)
(Option)

4.2 Cautions on Connection

• When connecting or disconnecting the camera cables (for the camera head and
camera control unit), always turn off the power switch of the camera control unit
first. If not, the camera head may be damaged.
• When connecting the camera, always turn off the power of the camera control
unit and any other equipment connected.
1
Remove the camera head protection cover and mount a lens (option).
2
Connect the camera head and the camera control unit with the camera cable
(option).
3
Connect the VIDEO (or S-VIDEO) terminal of the camera control unit to a video
input terminal of a monitor, etc.
4
Connect a DC power supply (12V) to the DC IN 12V terminal of the camera control
unit.
• For DC power supply connecting to DC IN 12V terminal, use Class II DC power
supply approved according to EN60950 in Europe.
(Betrieb nur mit zertifiziertem AC-Adapter nach EN60950)
When camera is used in USA, use UL listed and/or CSA approved ungrounding
type AC adaptor with the specifications described below.
Power supply voltage:
Current rating:
Ripple voltage:
Connector:
8
Camera control unit
CAMERA
Camera cable
(Option)
DC12V ± 0.5V
More than 800 mA
Less than 50 mV(p-p)
HR10A-7P-4S (Hirose)
Pins 1, 2:
Monitor
VIDEO
DC IN 12V
DC 12V
DC power supply
e d
, Pins 3, 4: