Yamaha MOTIF ES Owner's Manual page 73

Adjust the microphone input level by using the
7
GAIN knob on the rear panel.
Set the audio input related parameters as
8
necessary from the AUDIO IN display ([PERFORM]
[EDIT] [COMMON]
For details about each parameter, refer to page 214 in the
Reference section.
When the optional AIEB2 or mLAN16E has been installed,
the [F5] AUDIO IN menu has two indications: "A/D" and
"AIEB2" or "mLAN16E." Here, call up the A/D display by
pressing the [SF5] button.
Store the settings as a User Performance in the
9
Performance Store mode (page 91).
Connecting audio equipment to the A/D
INPUT jack
The explanation below applies in particular to high-level audio
equipment, such as CD players, synthesizers, and other
keyboards.
Make sure to turn off the power of both the
1
MOTIF ES and the relevant audio equipment.
Plug the audio equipment cable to the A/D INPUT
2
jack on the rear panel.
L R
Switch the power of the connected audio
3
equipment on, then switch the power of the
MOTIF ES on.
A / D INPUT
GAIN
R L
[F5] AUDIO IN).
A / D INPUT
GAIN
R L
Playing the Keyboard (in the Performance Play mode)
Press the [PERFORM] button to enter the
4
Performance Play mode and select the desired
Performance.
Press the [UTILITY] button to enter the Utility
5
mode, press the [F2] I/O button, then press the
[SF1] INPUT button.
6
Set Mic/Line to "line."
Move the cursor to the "Mic/Line" parameter by using the
Cursor button and set it to "line" by using the [INC/YES]
button, [DEC/NO] button, or data dial.
n
When the output level of the connected equipment (such as a
microphone, guitar, bass) is low, set this parameter to "mic." When the
output level of the connected equipment (such as a synthesizer
keyboard, CD player) is high, set this parameter to "line."
n
This setting is available for all modes. If you wish to store this setting,
press the [STORE] button.
Adjust the audio input level by using the GAIN
7
knob on the rear panel.
L R
Set the audio input related parameters as
necessary from the AUDIO IN display
8
([PERFORM] [EDIT]
AUDIO IN).
For details about each parameter, refer to page 214 in the
Reference section. When an optional AIEB2 or mLAN16E has
been installed, press the [SF5] button to call up the A/D display.
Store the settings as a User Performance in the
9
Performance Store mode (page 91).
n
Audio input signals from the OPTICAL INPUT and DIGITAL INPUT
connector (when the optional AIEB2 has been installed) or the mLAN
connector (when the optional mLAN16E has been installed) can also
be handled as Audio Input Parts. For details, see page 165.
A / D INPUT
GAIN
R L
[COMMON] [F5]
73
Owner's Manual