Using An Effect Plug-In Board - Yamaha MOTIF ES Owner's Manual

Using the Plug-in Board

Using an Effect Plug-in Board

In the example explanation below, the PLG100-VH Vocal Harmony Plug-in Board is used to apply harmony effects to the
microphone sound in the Performance mode.
n
For Songs/Patterns, the Effect Plug-in Board related parameters (which correspond to step #6 - 7 below) can be edited in the Song Mixing mode/Pattern
Mixing mode.
n
Please note that the Effect Plug-in Board cannot be used in the Voice mode.
After turning the power off, install the Effect
1
Plug-in Board PLG100-VH to slot 1.
See page 283 for details.
Plug the microphone to the A/D INPUT jack on
2
the rear panel (page 72).
n
A standard dynamic microphone is recommended. (The MOTIF ES
does not support phantom-powered condenser microphones.)
3
Turn the MOTIF ES power on.
Press the [PERFORM] button to enter the
Performance Play mode, select the desired
4
Performance, then set the microphone related
parameters.
For details, refer to steps #4 - 9 on page 72.
Check the status of the installed Plug-in Boards
5
in the [UTILITY]
display.
Select "PartAD" as the Part to which the Plug-in
Insertion Effect is applied in the CONNECT
6
display ([PERFORM]
CONNECT).
Move the cursor here, then select the Part.
78
Owner's Manual
A / D INPUT
GAIN
R L
[F6] PLUG [SF1] STATUS
[F3] EFFECT [SF1]
Set related parameters (such as the Effect Type,
and others) from the Plug-in Effect display
7
([PERFORM] [EDIT]
EFFECT [SF3] PLG-EF).
For details, refer to the Owner's Manual of the PLG100-VH.
Sing or talk into the microphone to check the
8
effect sound, and adjust the settings as
necessary.
A / D INPUT
R
If desired, store the settings for the microphone
9
sound and PLG100-VH as a Performance in the
Performance Store mode (page 91).
[COMMON] [F6]
GAIN
L