Yamaha MOTIF ES Owner's Manual page 25

# GAIN knob
For adjusting the input gain of the audio at the A/D INPUT
jacks (above). Depending on the connected device
(microphone, CD player, etc.), you may need to adjust this
for optimum level.
$ CARD (Card slot)
Insert a SmartMedia (memory) card here to transfer
various data to/from this instrument. Read carefully the
precautions on using a SmartMedia (page 28) before
inserting a SmartMedia card.
% Plug-in board cover
Installing an optional Plug-in Board to this instrument lets
you greatly expand the sonic palette of the instrument. Up
to three boards can be installed to the rear panel.
When the optional mLAN16E has been
installed:
1
mLAN EXPANSION BOARD mLAN16E
2 1
1 mLAN (IEEE1394) connector 1, 2
For connecting mLAN devices or IEEE1394-compatible
(FireWire) devices via standard IEEE1394 (6-pin) cables.
About mLAN
"mLAN" is a digital network designed for musical applications.
It uses and extends the industry standard IEEE 1394 high
performance serial bus.
For details, refer to the Guide Book of the mLAN16E.
* The name "mLAN" and its logo (above) are trademarks.
n
The digital audio output via the mLAN connector is fixed to a
resolution of 24 bit/44.1 kHz.
Page 73
Page 27
1 OPTICAL IN, OUT connectors
Page 283
2 DIGITAL IN, OUT connectors
IEEE1394
ACTIVE
MADE IN JAPAN
3 ASSIGNABLE OUT jacks (AS1 to AS6)
When the optional AIEB2 has been
installed:
1 2
Use these connectors to input or output digital signals
over optical-fiber cable. You can use the OPTICAL IN to
record a digital signal at frequencies of 48kHz, 44.1kHz,
or 32kHz. The OPTICAL OUT connector outputs a digital
signal of 44.1kHz.
Use these connectors to input or output digital signals
over coaxial (RCA-pin) cable. The digital signal format is
CD/DAT (S/P DIF). You can use the DIGITAL IN connector
to record a digital signal at frequencies of 48kHz,
44.1kHz, or 32kHz. The DIGITAL OUT connector outputs a
digital signal of 44.1kHz.
Line level audio signals are output from this instrument via
these phone jacks (1/4" mono phone plug).
These outputs are independent of the main output (at the
L/MONO and R jacks above), and can be freely assigned
to any of the Drum Voice key or the Parts. This lets you
route specific Voices or sounds for processing with your
favorite outboard effect unit.
The parts which can be assigned to these jacks are as
follows:
• Drum Voice key to which the drum/percussion instrument is
assigned
• Any part of a Performance*
• Any part of a Song*
• Any part of a Pattern*
* Including the Audio Input part
n
Digital audio output via the OPTICAL OUT connector or DIGITAL
OUT connector can be changed between 20-bit and 24-bit
resolution in the [UTILITY]
The frequency, however, is fixed at 44.1 kHz.
Rear Panel
3
Pages 33, 34
Pages 33, 34
Page 31
Page 203
Page 219
Page 235
Page 235
[F2] I/O [SF2] OUTPUT display.
Owner's Manual
25