Yamaha MOTIF ES Owner's Manual page 179

Effect connection in each mode
In the Voice mode
The Effect parameters in the Voice mode are set for each Voice and the settings are stored to internal flash ROM as a User Voice.
Please note that the Master Effect and Master EQ parameters are set for all the Voices in the Utility mode and stored to internal
flash ROM as System settings by pressing the [STORE] button also in the Utility mode.
[VOICE] Voice selection [EDIT]
[F6] EFFECT [SF1] CONNECT
Tone Generator block
Element or Key
Element EQ
You can set which Insertion system, A or B,
is applied to each Element (or to each key
when the Drum voice is selected). The
Insertion effect can also be bypassed.
n
The parallel connection is not available for Plug-in voices.
n
The Plug-in Insertion effect (when the Effect Plug-in board has been installed) is not available in the Voice mode.
In the Performance mode
The Effect parameters in the Performance mode are set for each Performance and the settings are stored to internal flash ROM
as User data.
[PERFORM] Performance selection
[COMMON] [F6] EFFECT [SF1] CONNECT
The Insertion connection type
depends on the setting of the Voice
assigned to the selected part.
Tone Generator
block
Part 1
Part EQ
*3
*2
*2
Audio Input part
*1
[COMMON]
System Effect
Reverb (REV), Chorus (CHO)
Insertion Effect
Send Level
You can select the Insertion connection
from the three types shown below.
A to B
A
B
[EDIT]
Reverb (REV), Chorus (CHO)
Send Level
Part 1
Insertion Effect
(VCE INS)
A
B
Plug-in Insertion Effect
(PLG-EF)
When the PLG100-VH
has been installed
[VOICE] [UTILITY] [F3] VOICE
Return Level
(for all Voices)
Master Effect
B to A parallel
A A
B B
System Effect
*4
Return Level
Master Effect
[PERFORM] Performance selection
[COMMON] [F2] OUT/MEF [SF3] MEF
*1
Among all of the audio input Parts, the Insertion effect can be applied
only to the A/D Input Part.
*2
Select the part to which the Plug-in Insertion effect is applied from Parts 1-4,
Plug-in Parts 1-3, and the audio input Part in the following display.
[PERFORM] Performance selection
EFFECT [SF1] INS SW
*3 [PERFORM] Performance selection
*4 [PERFORM] Performance selection
[COMMON] [F2] OUT/MEF
*5
[PERFORM] Performance selection
[COMMON] [F2] OUT/MEF
[PERFORM] Performance selection
[COMMON] [F1] GENERAL
Internal Structure (System Overview)
[SF2] MEF
Master EQ Output
[VOICE] [UTILITY] [F3] VOICE
[SF1] MEQ (for all Voices)
[VOICE] Voice selection [EDIT]
[COMMON] [F1] GENERAL [SF3]
MEQ OFS
*5
Master EQ Output
[EDIT]
[EDIT] [COMMON] [F6]
[EDIT] Part selection [F3] EQ
[EDIT]
[SF1] OUT
[EDIT]
[SF2] MEQ
[EDIT]
[SF3] MEQ OFS
Owner's Manual
179