Yamaha MOTIF ES Owner's Manual page 140

Using as a Master Keyboard
Assigning Control Change numbers to the Knobs/Sliders for each Zone
Here in the KN/CS display of the Master Edit mode, you can set how the Control Knobs and Sliders will affect each Zone. This
lets you specify a separate MIDI Control Change number for each Knob and Slider.
Set the parameters as shown below, corresponding to step #6 on page 138.
All indicators are turned off by setting the
[MASTER]
Knob/Slider parameter to "zone."
In the example above, the Control Knobs for all Zones have been set to 10 (Pan), and the Sliders have been set to 11
(Expression). In this way, you can control the stereo position of each Zone with the appropriate Knob, and use the Sliders to
adjust the relative volume balance among the Zones.
140
Owner's Manual
[EDIT] [COMMON] [F2] OTHER
ASSIGN A ASSIGN B
PAN/SEND PAN REVERB
CUTOFF RESONANCE
ASSIGN
SWING GATE TIME
TONE
KNOB
CONTROL
FUNCTION
ARP FX
1
KN KN
LOW LOW MID
EQ
VOLUME VOLUME 1 1 VOLUME VOLUME
CS 1 CS 1 CS 2
MASTER
VOLUME
ZONE 1 ZONE 1 ZONE 2 ZONE 1
You can determine which Control Change numbers are used for the Knobs
and Sliders for each zone in the [MASTER]
[F5] KN/CS display.
ASSIGN 1 ASSIGN 2
CHORUS TEMPO
ATTACK RELEASE
VELOCITY UNITMULTIPLY
2 3 4
KN KN
HIGH MID HIGH
2 1 VOLUME VOLUME 1 3 VOLUME VOLUME 4 1
CS 3 CS 4
ZONE 1 ZONE 3 ZONE 4 ZONE 1
[EDIT] Zone selection